NEW Product.....

FROST-N-SNOW BUSTER ™ FOR CAR OR TRUCK WINDSHIELDS AND FRONT SIDE WINDOWS

Place it over the wiper and tie it to two side windows. This product also helps to minimize or eliminate frost in the inner side of windshield.


 

 



Just one piece may be sufficient for your driving needs. However, if you want to keep larger portions of the windshield clean, use two pieces over the front windshield. They can be tied in different ways so that they are not blown away by the wind.

 

 

 

After removal of the one or two of the Frost-N-Snow Buster sheets, you will notice that the windshield is free and clear of any ice and snow buildup, allowing you clear visibility. It will also allow you to decrease the time it takes to get to your destination in the morning.

 

 

 

 

To get your vehicle ready faster in the morning during winter months when parked outside, we are introducing the “green” product called FROST-N-SNOW BUSTER™ with the following important features:

• It is sufficiently rigid not to crimp or fold or slide downward and soft enough to almost conform to your windshield
• No folding necessary to fit the width – just overlap the two pieces in the center
• Not a chemical type which will deplete or might damage the rubber or paint
• It is not a type where it is held in place by door or windows where possibilities exist for leakage of frost and water inside cars or trucks.
• Can be kept in rear seats with wet side exposed to dry during the day or can be hanged through two hooks indoor…
• Light weight, < 2lb per piece


HOW TO USE

Place it over the wiper and tie it to two side windows.


DAY TIME STORAGE AFTER REMOVAL IN THE MORNING

After removal of the Frost-N-Snow Buster™ in the morning, it must be kept properly so that it dries up for reusing in the evening. One advantage of this product over cloth is that the water on it can be wiped away using a dry towel which may not be necessary if it is properly stored during the day.


It can be hung inside garage using one or more hooks exposing the frosted sides outward.

 

 

 

 

 

Alternatively, it can be kept in the back seat of the vehicle with the frosted side exposed.

 

 




CHOOSING THE RIGHT SIZE FOR YOUR CAR OR TRUCK

Frost-N-Snow Buster ™ is available in three different sizes, namely SMALL, MEDIUM and LARGE to fit all cars and trucks. Two pieces are needed to cover most of the windshields and part of side window for clear vision through side mirrors. Each piece covers almost half of windshield and part of one side front window. Clean part of front side window when used in conjunction with mirror cover, no scrapping is needed for visibility through the window.

Measure the length along the windshield at its mid-section from the top to the bottom surface contact of the cover (see illustration).

If the length is 35” or less, then you need a SMALL size. If the length is between 35” and 40”, then you need a MEDIUM size, and if the length is greater than 40”, then you need a LARGE size.

 

 

 


Disclaimer


Use it at your own risk.

 
 
 
 

Please report any errors on this site to our WebMaster.